SOLD: Citation Formula Ford Race Car

Please note that I have sold this on December 11, 2009.

For sale is an immaculate condition, restored and updated Citation Formula Ford. The race car was stripped down to a bare chassis in 2001 and everything on the car was either rebuilt or replaced with newer technology. It also has a new engine built by Jim at Justice Racing Engines with a "runoffs" aluminum head and forged pistons with no track time. The car is complete, race-ready with spares and log books are available. Since the restoration the car has not been road raced. The car has competed in two autocross events for final engine and chassis tuning.

General Specifications:

• Make: Citation
• Model: 84F FF w/ suspension updates
  
• Wheelbase: 96"
• Track: 59.5" front, 57" rear
  
• Weight: 850lbs w/o driver
• Engine: Ford "Kent" 1.6L (new)
  
• Chassis no: 840585
• Legal in SCCA FF road racing and CM autocrossing
• Bodywork painted Red and Blue with exact PPG paint codes from a 1990 Nissan GTP ZX-T.
  

Chassis Specifications:

• Powder coated red chassis with no crash damage
• Hewland MK9 - smooth shifts
  
• Panasport magnesium wheels
  
• New engineered pushrod rear suspension - created by ICP in 2002
• Penske 8100 Double Adjustable shocks with custom valving for chassis and setup
• AiM Mychron 3 XG Log - datalogger and digital dash (steering, brake, throttle, G forces, engine rpm, engine oil pressure, engine water temp, o2, lap counter), cables and track side sensor and 8MB of data storage
  
• Hypercoils springs - 1700lbs front, 450lbs rear
  
• Aluminum belly pan - anodized and bonded to chassis with Hysol
  
• Custom fuel cell built by ATL in 2006
• Willians 5-point harness - valid till 2011
• Momo suede steering wheel with quick release
• Fire suppression system with full bottle
• New wiring and switch panel
• All new aluminum and panels during restoration
  
• LED rain light
• New CV joints and boots

Engine Specifications:

• Complete engine built, dyno'd and tuned by Justice Race Engines.
  
• 711M Cast iron block
• Aluminum heads - runoff quality
  
• Jet hot coated headers and collectors with o2 sensor and port
  
• Titan 5-port dry sump pump
• Aluminum oil pan from a Swift DB-1
  
• Lightened and balanced flywheel - SCCA legal
  
• Tilton 7.25" racing clutch with buff spring
• Tilton Super Starter
• Ramair foam airfilter
• Braided stainless steel oil and fuel lines
• MicroDynamics Smoothcut Rev Limiter
  

Spares and parts:

• Gears: (autocross + road racing) 14:36, 17:33, 17:34, 18:32, 20:30, 21:30, 22:29, 22:30, 23:28, 23:28, 25:26
  
• (5) Panasport wheels with (4) Goodyear rain tires - red powder coated
• Spare Ford Cortina block
  
• (4) street wheels and tires - for off-season storage
  
• Roll hoop upgrade - created by ICP to double torsional rigidity of chassis
• Formula car Jack
  
• Master cylinders and reservoirs
• Complete carburetor jet set and rebuild kits
• Taylor digital scales
• Ferodo brake pads
• Stock connecting rods
• Lucas starter
• Bosch coil
• Engine gasket sets (multiple sets)
• Brake bleeding system - single person via air compressor
• (2) Side pod belly pan panels
• Custom engine stand - for storage and shipping
• (2) Hypercoils springs (800lbs)
• Foam impact material - 2 sq. feet from IndyCar manufacturer
• Exhaust headers and collection tube
• Clear leading edge tape - saves the paint!
• Gear change tray
• Miscellaneous stainless steel braided and rubber hoses
• Fiberglass pipe insulation and fluid reservoirs
• (2) 5 Gallon fuel jugs
  
• Book "Hanes Weber carburetor rebuild"
• Book "How to Build and Maintain Competitive FF 1600 Engines" by Jake Lamont.

Trailer

• 1997 20' Enclosed Haulmark custom car trailer with many "Pit Products" aluminum accessories
  
• Red exterior - has been recently sanded and patched - need fresh paint
• 36" side door
• Rear spring assisted ramp door
• (2) roof vents - new
  
• (2) Aluminum tire racks
• (2) Aluminum fuel jug holders 
• Aluminum paper towel and shop towel holders 
• Aluminum oil holder - for quart oil bottles
• (2) Aluminum accessory boxes
• (2) Aluminum fluid and bottle holders
• Custom side canopy - 10' x 20'
  
• Electric winch and battery - for easy load and unloading (not shown in pictures)
• Wall that separates car from living quarters.
• Work bench and storage shelves
• Fold down bunk beds with custom foam inserts
• Aluminum dual helmet and coat rack
• Hitch with load equalizer bars and electric brakes
  

Price:

• $15,000 for car and spares package
• $5,000 for trailer
• Package deal: $19,000 for car, spares, and trailer
• We will consider package deal offers first
  

For more information, please contact Chris More by email or phone at 814-883-1418

Photo Gallery: